Press Esc to close
proaudioeurope.com

Europe's Largest Stockists of New and Used Professional Audio Equipment

Quested S6R MkIII Active Monitors (Pair)

Quested S6R Active 2-Way near Field Monitors - Front

Quested S6R MK III Active 2 Way Near Field Monitors, 45w/65w RMS

Quested S6R MK III Active Monitors

Originally designed to partner the SB10R subwoofer in a 3-way system, the sonic performance of the S6R belies its size. Easy to position where space is limited, the low frequency response is more than adequate for many applications. However, when an extended bass response is required the infinite baffle cabinet design facilitates perfect integration with SB10R sub-woofer which will extend the frequency response down to 25Hz. The S6R is phase coherent with the S7R and S8R, enabling it to be used in combination with both in multi- channel systems.

This compact self-powered 2-way active monitor is the ideal choice where space is at a premium; the magnetic shielding also facilitates its use in close proximity to CRT monitors.

A perfect choice for 5.1 systems where space is limited. Typical applications also include: speech recording, component in multi-channel systems, postproduction, Audio workstations and location recording.

Quested S6R MK III Specifications

  • Size (WxHxD) 170(w) x 285(h) x 240(d) mm
  • Weight 7.5 kgs
  • Drivers Bass cone - 1 x 130 mm (5”), High Frequency soft dome - 1 x 28 mm (11/8”)
  • Maximum SPL 104 dB (c) continuous pink noise @ 1 m (116 dB (c) per pair RMS music)
  • Frequency Response 75 Hz-20 kHz ± 2 dB
  • Connector XLR and 1/4 inch Jack combo socket
  • Impedance 10k ohm electronically balanced with RF filters
  • Wiring Pin 1 ground Sleeve, Pin 2 hot Tip ,Pin 3 cold Ring
  • Sensitivity -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear
  • Filters
  • Subsonic -3dB @ 45 Hz, 24dB/oct
  • Ultrasonic -3dB @ 75 kHz, 4dB/oct
  • Crossover 1k19
  • LF EQ -2/-4 @ 82 Hz
  • HF EQ +/- 2dB @ 10 kHz
  • Power Amplifier
  • LF output power > 65W RMS continuous (note 1)
  • HF output power > 45W RMS continuous (note 1)
  • T.H.D. < 0.03% at levels up to 1 dB below clip, 20 Hz-20 kHz. typ 0.005% @ 1kHz.
  • Hum + Noise > -100 dB referred to clip
  • NOTE 1: The continuous rating is for a period not exceeding 5 minutes with unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding 30ºC.
  • Indication Power on
  • Front mounted green LED indicates power applied.
  • Clip Red LED 2 dB before amplifier clip.
  • Power requirements
  • Voltage Set by internal plugs: nominal 115V or 230V @ 50-60 Hz AC
  • 230V setting: min 160V; restricted output power: max 255V
  • 115V setting: min 80V; restricted output power: max 127V
  • Consumption Quiescent: 12W; Typical use: 45W (average music); Max: 90W (average music)
Share This: